Separ 2000 FAQ’s

To put the handle on the first time, make sure the bar is in the neutral position. The valve handle must be parallel to the filters when installed.

The table below specifies the recommended torque values for the filter assembly.

Use the eyelet screws to attach a chain that can then be attached to a lift. NEVER pick up by the handle as it will break.

Ensure to tighten screws evenly in the sequence shown.

You only need to use 3-5 lbs of torque to tighten correctly. If it is still leaking, replace the gasket.

Ensure to tighten screws evenly in the sequence shown.

On the front of the filter housing is a white and blue label. This shows model number and part number for the replacement element. If the label is not visible or your filter does not have one, you can click on the models and spec button of this website and click on the appropriate sized filter to find out which element you need.

Make sure to push the drain valve down and turn to the left. Otherwise, you will break off the yellow tab when tightening.

NEVER clean the clear bowl with Windex or any type of cleaner with chemicals. The bowl will spider crack once you add the diesel fuel back in. You can only use non-chemical products (i.e., Simply Green, et al.) or we also suggest cleaning it with diesel fuel.

The table below specifies the water holding capacity up to the contacts of the filter bowl.

If you only have a single filter, then you need to buy the Single Water Contacts.

If you have a duplex filter, then one filter uses a set of Single Water Contacts and the second filter uses a set of Double Water Contacts.